I have had my nanosyncs (Ver.3) for a few weeks, and have it as master clock to an AD8000SE, ADAT Bridge24, 882/20, and a Ramsa DA7. I run a MixCore and 2 farm cards. What is the proper settings for this unit to supply WordClock (SuperClock I assume) to all the digi related hardware, and the DA7? Also, what are the internal settings for this within PT? I currently have it attached to the WordClock in on the AD8000, slave clock on the other digi hardware, and into the DA7, via the V-sync (auto termination) card. No problems (crackling, WC dropout, etc), but want to know what is the definitive routing for this setup? Also, I cannot seem to get the ADAT Bridge I/O's available on the PT mixer, but shows up correctly in hardware setup, as well as in the I/O menu? All I/O's past the first 8 show up as 882/20 - What gives? Cheers,

Have you tried trashing the digi setup?

Jules, I had trashed digi setup in 5.0.1 expecting this to resolve it. Unfortunately, not. I recently installed 5.1.3 and did a fresh setup with all the hardware prefs. as stated, and have the same results.